Setting The Usb Keyboard Type; Saving System Memory Data - Fostex UR-2 Owner's Manual

Model UR-2 <MENU mode / SYSTEM SETUP menu>

Setting the USB keyboard type

When you connect a USB keyboard to the [USB
(KYBD ONLY), select the USB keyboard type ("US"
or "JAPAN") correctly.
The setting is stored to the internal flash ROM.
By using the [MENU] dial to highlight "Keyboard
type" in the SYSTEM SETUP menu and pressing
the [ENTER] key, the current setting starts flash-
ing and you can now select the keyboard type
(the default setting is "US").
Use the [MENU] dial to select the type between
"US" and "JAPAN", and press the [ENTER] key to
confirm the setting.
Select when you connect a US keyboard.
US
Select when you connect a Japanese key-
JAPAN
board.
To exit the [MENU] mode, press the [STOP] key
(or the [EXIT] key).
Flashing
-78-

Saving system memory data

You can save system memory data which con-
tains settings in the SYSTEM SETUP menu, PLAY
SETUP menu, etc. to the internal flash ROM or
the current storage device. See the next page for
the data to be saved.
The saved data can be loaded to the UR-2 so you
can apply the same system settings to multiple
UR-2 units, or you can apply the desired system
settings by loading a set of typical settings.
By using the [MENU] dial to highlight "SYS. user
save" in the SYSTEM SETUP menu and pressing
the [ENTER] key, the display shows the screen
for selecting the destination.
Internal
Data is saved to the internal Flash ROM.
FROM
Current
Data is saved to the current storage device
(SD1, SD2 or USB).
device
By using the [MENU] dial to select "Internal
FROM" or "Current device" and pressing the [EN-
TER] key, the following screen appears. Pressing
the [ENTER] key again executes the save opera-
tion. (The following shows the screen example
when selecting "Internal FROM".)
After finishing the save operation, "Completed"
is shown. See the table in the next page for the
contents of the data to be saved.
To exit the [MENU] mode, press the [STOP] key
(or the [EXIT] key).
Flashing