Loading The System Memory Data - Fostex UR-2 Owner's Manual

The following shows the contents of the data to
be saved.
• SYSTEM SETUP menu
(1) File name mode (2) Selet input
(3) Record FS/bit (4) Record CH.
(5) Record mode (6) Max. file length
(7) Peak hold time (8) REF. level
(9) Cue monitor out (10) Digital out
(11) Display INV. (12) Keyboard type
• PLAY SETUP menu
(1) Play mode (2) Repeat
(3) Auto play (4) PowerOn Play
(5) Mono mix
• MIC IN SETUP menu
(1) Mic in (2) Switch hold
(3) Play ATT. (4) Mic record
(5) Phantom
• REMOTE SET menu
(1) Remote sel. (2) Parallel setup
(3) RE232C setup
• Display brightness level
After the software is upgraded, setting
<Note>:
data which has been saved to the current de-
vice (SD card or USB memory) with the older
software version may be unusable.
Model UR-2 <MENU mode / SYSTEM SETUP menu>

Loading the system memory data

You can load system memory data saved by us-
ing the "SYS. user save" item in the SYSTEM SETUP
menu (see the previous page for the "SYS. user
save" item).
By using the [MENU] dial to highlight "SYS. user
load" in the SYSTEM SETUP menu and pressing
the [ENTER] key, the display shows the screen
for selecting the loading source (the internal flash
ROM or the current storage device).
Internal
Data is loaded from the internal Flash ROM.
FROM
Current
Data is loaded from the current storage de-
vice (SD1, SD2 or USB).
device
By using the [MENU] dial to select "Internal
FROM" or "Current device" and pressing the [EN-
TER] key, the following screen appears. Pressing
the [ENTER] key again executes the load opera-
tion. (The following shows the screen example
when selecting "Internal FROM".)
After finishing the load operation, "Completed"
is shown.
To exit the [MENU] mode, press the [STOP] key
(or the [EXIT] key).
-79-
Flashing