Canon NP6320 Service Manual page 183

4. Installing the Lens Drive Cable
This unit has been accurately adjusted at the factory with special gauges. Do not remove parts
other than those shown below, nor loosen any other screws.
Lens pulley
[3]
4 turns
Mounting screws
[4]
Mark with scriber
Pulley mount
a. Removing the Lens Wire
1) Unscrew the three screws; then remove the upper frame.
2) Mark the positions of the pulley fixing base and the wire fixing with a scriber.
3) Unscrew the two screws used to hold the pulley fixing base.
4) Remove the wire.
b. Attaching the Lens Wire
1) Unscrew the two screws used to hold the lens pulley fixing plate, and remove the lens pulley.
(See Figure 10-206.)
2) Wind the lens wire around the lens pulley as shown in Figure 10-206, and fix it with the two
fixing screws.
3) Shift the pulley fixing base to the position of the scriber mark; then fix it with the two fixing
screws.
COPYRIGHT © 1999 CANON INC.
[2]
Lens pulley fixing plate
Mark with scriber.
[5]
Cable mount
Figure 10-206
CANON NP6320 REV.0 DEC. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 TROUBLESHOOTING
[1]
10-5