Canon NP6320 Service Manual page 182

CHAPTER 10 TROUBLESHOOTING
2. Leading Edge Registration
Make adjustments in the service mode (C02) so that the distance shown is 10.0 ±1.5 mm when
the test sheet is copied in Direct.
Note:
Adjust the leading edge non-reproduced area before making this adjustment.
A higher setting in the service mode (C02) increases the leading edge margin.
3. Side-to-Side Registration
The standard near side registration on a Direct copy of the test sheet is 10.0 ±2 mm.
Loosen the two screws, and adjust the latch assembly for the cassette found on the back of the
bottom plate by sliding it.
10-4
COPYRIGHT © 1999 CANON INC.
Figure 10-203
0
2
4
6
8
10 + 2 mm
10
Figure 10-204
Feeder release
Screws
lever
Cover
Figure 10-205
CANON NP6320 REV.0 DEC. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
10.0 + 1.5 mm