Canon NP6320 Service Manual page 148

CHAPTER 7 EXTERNAL/AUXILIARY MECHANISMS
E. PCBs
1. DC Controller PCB
1. Removing the DC controller PCB
1) Remove the rear cover.
2) Disconnect the all connectors on the DC
controller PCB.
3) Remove the two srews [1] and then re-
move the DC controller PCB [2] with its
mount.
2. Power Supply PCB
1. Removing the Power Supply PCB
1) Remove the rear cover.
2) Disconnect all the connectors on the
power supply PCB.
3) Remove the two screws [1], and then re-
move the power supply PCB [2] with its
mount.
Note
J111 and J112 are interchangeable.
7-10
COPYRIGHT © 1999 CANON INC.
[1]
Figure 7-216
[2]
Figure 7-217
CANON NP6320 REV.0 DEC. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[1]