Canon NP6320 Service Manual page 109

3. Positioning the Pick-Up Roller
Attach the pick-up roller to the pick-up
shaft as shown in Figure 5-312; make sure that
the pick-up roller is fitted into the mounting
hole.
4. Detaching the Multifeeder Roller
1) Detach the right door; see p. 7-4.
2) Disengage the four hooks [1], and detach
the U-turn guide unit [2].
3) Push and turn the pad spring support [3]
assembly found at the bottom of the right
door unit 90°.
COPYRIGHT © 1999 CANON INC.
CHAPTER 5 PICK-UP/FEEDING SYSTEM
Mounting holes without notation
are inch/metric configurations.
CANON NP6320 REV.0 DEC. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
(front)
Pick-up shaft Mounting hole (inches)
Mounting hole (metric)
Metric configuration only.
Figure 5-312
[1]
[2]
[1]
Figure 5-313
[3]
Figure 5-314
(rear)
5-15