Serial Port - Brady Bradyprinter THT 300X-Plus II Manual

Data Ports
Standard Ports

Serial Port

To communicate using the serial data port of the printer, you must choose the number
of data and stop bits, parity, and handshaking. Parity applies only to data transmitted
by the printer because the parity of received data is ignored.
The values selected must be the same as those used by the host equipment connected
to the printer. Default settings are 9600 baud, 8 data bits, 1 stop bit, no parity, and
XON/XOFF.
Connect the serial data cable to the female DB-9 connector (shown below) on the back
panel of the printer.
Use a DB-9 to DB-25 interface module for all RS-232 connections through a DB-25
cable. An interface module is required for RS-422/RS-485 interface support
(see RS-422/RS-485 Interconnections
Note • For all RS-232 input and output signals, the printer follows the specifications
of the Electronics Industries Association (EIA) RS-232 and the Consultative
Committee for International Telegraph and Telephone (CCITT) V.24.
58
on page 63).
Bradyprinter THT X-Plus II Series User Guide