Brady Bradyprinter THT 300X-Plus II Manual page 111

LCD Description
INIT FLASH MEM Initialize Flash Memory
Caution • Perform this operation only when it is necessary to erase all
previously stored information from Flash memory.
1. When the LCD displays INITIALIZE CARD , press the right oval to select YES . (If
2. Press the right oval YES .
3. Do you wish to continue?
Sensor Profile
SENSOR
PROFILE
The media sensor profile may be used to troubleshoot registration problems
that may be caused when the media sensor detects preprinted areas on the
media or experiences difficulty in determining web location.
• Press the right oval to start this standard calibration procedure and print a
media sensor profile.
See the media sensor profile below. If the sensitivity of the media and/or
ribbon sensors must be adjusted, use Calibrate Media and Ribbon Sensors
on page 84
Media Sensor Profile
Bradyprinter THT X-Plus II Series User Guide
you are prompted for a password, enter your password using the instructions
in Password-Protected Parameters
The LCD asks INITIALIZE FLASH.
The LCD asks ARE YOU SURE?.
• Press the left oval to select NO to cancel the request and return to the INIT
FLASH MEM prompt.
• Press the right oval to select YES and begin initialization.
When formatting is complete, INIT FLASH MEM displays.
to adjust the media and ribbon sensor sensitivity.
Front Panel Controls
on page 74
.)
Front Panel LCD
83