Pause Self Test - Brady Bradyprinter THT 300X-Plus II Manual

PAUSE Self Test

This self test can be used to provide the test labels required when making adjustments
to the printer's mechanical assemblies. See the sample printout below.
To perform a PAUSE self test, complete these steps:
1. Turn Off (O) the printer.
2. Press and hold PAUSE while turning the power On (I). Hold PAUSE until the
DATA light turns off.
• The initial self test prints 15 labels at 2.4 in. (61 mm) per second, then
automatically pauses the printer. When PAUSE is pressed, an additional 15
labels print. The labels are like the one shown below.
• While the printer is paused, pressing CANCEL alters the self test. When
PAUSE is pressed, 15 labels print at 6 in. or 152 mm per second.
• While the printer is paused, pressing CANCEL again alters the self test a
second time. When PAUSE is pressed, 50 labels print at 2.4 in. (61 mm per
second).
• While the printer is paused, pressing CANCEL again alters the self test a third
time. When PAUSE is pressed, 50 labels print at 6 in. (152 mm) per second.
• While the printer is paused, pressing CANCEL again alters the self test a
fourth time. When PAUSE is pressed, 15 labels print at the printer's
maximum speed.
• To exit this self test at any time, press and hold CANCEL.
Bradyprinter THT X-Plus II Series User Guide
Troubleshooting
Printer Diagnostics
125