Front Panel Buttons - Brady Bradyprinter THT 300X-Plus II Manual

Introduction
Front Panel

Front Panel Buttons

This table describes the function of the buttons shown in the illustration on
Button Details
LEFT OVAL Changes parameter values. Common uses are to increase/decrease a value,
answer yes or no, indicate on or off, scroll through several choices, input the
password, or set up the printer for a firmware download.
RIGHT OVAL Changes parameter values. Common uses are to increase/decrease a value,
answer yes or no, indicate on or off, scroll through several choices, input the
password, or set up the printer for a firmware download.
PREVIOUS
Scrolls to the previous parameter. Press and hold this button to scroll back
quickly through parameter sets.
NEXT/SAVE Scrolls to the next parameter. Press and hold this button to scroll forward
quickly through parameter sets.
SETUP/EXIT Enters and exits the setup mode.
PAUSE
Starts and stops the printing process and allows other buttons to be used. If an
error messages is on the LCD, pressing this button removes the error.
FEED
Forces the printer to feed a blank label each time the button is pressed.
• If the printer is not printing, one blank label immediately feeds.
• If the printer is printing, one blank label feeds after the current batch of
labels is complete.
CANCEL In the pause mode, this button cancels print jobs.
• If there are multiple print jobs in the print queue, press CANCEL once for
each print job to be deleted.
• To delete all print jobs, hold CANCEL for several seconds. The DATA light
turns off.
CALIBRATE
This button can be used to calibrate the printer for the following:
• Media length
• Media type (continuous or non-continuous)
• Print mode (direct thermal or thermal transfer)
• Sensor values
For more information on calibration, see Calibrate the Printer
4 Bradyprinter THT X-Plus II Series User Guide
page 2.
on page 33.