Brady Bradyprinter THT 300X-Plus II Manual page 51

To load roll media, complete these steps:
1. Open the printhead.
2. Slide the media guide away from the printer frame. You might need to loosen the
media guide screw.
3. Put the roll of media on the media hanger.
4. Push the label core toward the printer frame. The labels must be aligned with the
label core.
5. Feed the media under the media guide roller and under the printhead.
6. Do you have the Cutter option?
• No — continue with the next step.
• Yes — feed the media through the cutter.
7. Adjust the media supply guide so it is just touching, but does not restrict, the edge
of the media. The labels should lie flat as shown in the illustration.
1
2
8. Are you using direct thermal labels?
• Yes — close the printhead and go to Print a Configuration Label
• No — go to Load Ribbon
Bradyprinter THT X-Plus II Series User Guide
Caution • The cutter blade is sharp. Do not rub or touch the blade
with your fingers.
1
Printhead
2
Media guide roller
3 Labels/media
on page 26.
Printer Operation
Load the Printer
3
on page 31.
23