Brady Bradyprinter THT 300X-Plus II Manual page 53

• From the rear slot in the printer body.
This illustration shows the printer with fanfold labels loaded through the rear
slot.
1
2
3
4. Do you have the Cutter option?
• No — continue with the next step.
• Yes — feed the fanfold media through the cutter.
5. Adjust the media guide so it just touches, but does not restrict, the edge of the
labels. The labels should lie flat.
6. Are you using direct thermal labels?
• Yes — close the printhead and go to Print a Configuration Label
• No — go to Load Ribbon
Bradyprinter THT X-Plus II Series User Guide
1
Printhead lever (shown in the Open position)
Media guide
Fanfold labels
Caution • The cutter blade is sharp. Do not rub or touch the blade
with your fingers.
2
on page 26.
Printer Operation
Load the Printer
3
on page 31.
25