Select A Site For The Printer; Select A Surface; Provide Proper Operating Conditions; Allow Proper Space - Brady Bradyprinter THT 300X-Plus II Manual

Getting Started

Select a Site for the Printer

Select a Site for the Printer

Consider the following when selecting an appropriate location for your printer.

Select a Surface

Select a solid, level surface of sufficient size and strength to accommodate the printer
and other equipment (such as a computer), if necessary. The choices include a table,
countertop, desk, or cart.

Provide Proper Operating Conditions

Because the printer was designed and is fabricated as an industrial-type unit, it
functions satisfactorily in a location that conforms to specified environmental and
electrical conditions, including a warehouse or factory floor. For more information on
the required conditions, see General Specifications
The following table shows the temperature and relative humidity requirements for the
printer when it is operating.
Mode
Thermal Transfer
Direct Thermal

Allow Proper Space

The printer should have enough space around it for you to be able to open the media
door. To allow for proper ventilation and cooling, leave open space on all sides of the
printer.
Caution • Do not place any padding or cushioning material behind or under the
printer because this restricts air flow and could cause the printer to overheat.

Provide a Data Source

If the printer will be located away from the data source, the selected site must provide
the appropriate connections to that data source. For more information on the types of
communication interfaces, see Communication Interfaces
12
Temperature
41° to 104°F (5° to 40°C)
32° to 104°F (0° to 40°C)
on page 133.
Relative Humidity
20 to 85% non-condensing
20 to 85% non-condensing
on page
Bradyprinter THT X-Plus II Series User Guide
15.