Brady Bradyprinter THT 300X-Plus II Manual page 107

LCD Description
Setting Print Width
PRINT WIDTH
Print width determines the printable area across the width of the label.
To change value shown:
1. Press the left oval to move the cursor.
2. Press the right oval to increase the value of the digit.
Note • The printer does not accept any value larger than the maximum print
width listed in General Specifications
To change the unit of measurement:
1. Press the left oval until the unit of measurement is active.
2. Press the right oval to toggle to a different unit of measure (mm, inches,
Default Range: The default and range of acceptable values vary depending on
what printer you have. See General Specifications
information about the ranges available for your model.
Setting Maximum Length
MAXIMUM
LENGTH
Maximum length is used in conjunction with the calibration procedure. The
value of this setting is the maximum label length that is used during the media
portion of the calibration process. Only a few labels are required to set media
sensors. Always set the value that is at least 1 in. (25.4 mm) longer than the
longest label to be used on the printer.
• To increase the value, press the right oval.
• To decrease the value, press the left oval.
Default Range: The default and range of acceptable values vary depending on
your printer's configuration. Values are adjustable in 1 in. (25.4 mm)
increments.
Bradyprinter THT X-Plus II Series User Guide
or dots).
Front Panel Controls
Front Panel LCD
on page 133.
on page 133 for further
79