Brady Bradyprinter THT 300X-Plus II Manual page 148

Troubleshooting
Print Quality Problems
Problem
Intermittent creases on
the left and right edges
of the labels
Wrinkled Ribbon
120
Possible Cause
There is too much toggle
pressure on the
printhead.
The ribbon is not loaded
correctly.
The darkness setting is
incorrect.
Incorrect printhead
pressure or balance.
The labels are not
feeding correctly. They
are shifting from side to
side.
Recommended Solution
Reduce the toggle pressure. See Adjust
the Printhead on page
Caution • Observe proper
electrostatic safety precautions
when handling any static-
sensitive components such as
circuit boards and printheads.
Load the ribbon correctly. See Load
Ribbon on page 26
.
Set the darkness to the lowest possible
setting for good print quality. See
Adjusting Print Darkness
Set the pressure to the minimum required
for good print quality. See Adjust the
Printhead on page 39.
Caution • Observe proper
electrostatic safety precautions
when handling any static-
sensitive components such as
circuit boards and printheads.
Make sure that the media guide and
media supply guide touch the edge of the
media.
Adjust the ribbon strip plate.
Bradyprinter THT X-Plus II Series User Guide
39.
on page 76.