Basics - Panasonic WJ-ND400K Setup Instructions

Basics

Configure the system settings to operate the recorder.
Basics
Use the following procedure to configure basic system settings.
1
Click the [Basic] button on the setup menu.
2
On the sub-menu that appears, click [Basic].
This will display the setting window.
Basic setup
Item
Recording
LCD setup lock
Password
Language
Go to last before
Buzzer
Error output duration
Safe shutdown time
♦Initial default
Settings
Off / On♦
Off♦ / On
Enter password
(12345♦)
Japanese / English♦ / Français /
Español / Deutsch / Italiano /
Russian / Chinese / Custom
5s / 10s / 30s♦ / 1min / 5min
Off / 2s♦ / 5s / 10s / 20s / 30s /
1min / Ext
Off / 2s♦ / 5s / 10s / 20s / 30s /
1min / Ext
10s♦ / 20s / 30s / 1min / 2min /
3min / 4min / 5min
3
Configure the settings for each item.
Refer to "Basic setup" table for details about the settings.
4
Click the [Set] button.
Description
Specifies whether recording should be performed.
• Recording is not performed when [Off] is selected. Select
[On] for this setting except to force a recording to stop.
Locks front panel buttons to prevent them from being operated.
• When [On] is selected, buttons can be unlocked by entering
a password, but they will re-lock automatically if no operation
is performed for a certain period of time (about one minute).
Specifies a password for releasing LCD setup lock. Sets a
password of five single-byte characters.
Specifies the language used in browser screens.
• Contact your dealer for further information about the
customized language (Custom).
Specifies the time the image is displayed when the [Go to last]
button is clicked on the operation window.
Specifies the duration that the buzzer sounds whenever an
error occurs on the recorder.
• Selecting [Ext] causes the buzzer to continue to sound until
the [ERR] button is clicked or the [BUZZER STOP] button on
the front panel is pressed.
Specifies the duration of the error output whenever an error
occurs on the recorder. For details about error output, refer to
the Installation Guide.
• Selecting [Ext] causes signal output to continue until the
[ERR] button is clicked.
Specifies the time until shutdown starts after a power down
detection signal is input to the recorder.
31