Panasonic Alarm Protocol - Panasonic WJ-ND400K Setup Instructions

Panasonic alarm protocol

Use the following procedure to configure settings for sending a message to a preset address whenever an event or error occurs.
Up to four destinations can be specified.
Special separately available software
information.
* Refer to the "readme.txt" file on the CD-ROM for details about the software.
1
Click the [Network] button on the setup menu.
2
On the sub-menu that appears, click [Panasonic alarm
protocol].
This will display the "Panasonic Alarm Protocol Settings"
window.
Panasonic alarm protocol settings
Item
Port number (to PC)
Retry
Destination address
Address1 to 4
♦Initial default
*
must be installed on the PC receiving the notification in order to display the received event or error
Settings
Port number input (1818♦)
1 to 30 (2♦)
Address input
(Blank♦)
3
Configure the settings for each item.
Refer to "Panasonic alarm protocol settings" table for details
about the settings.
4
Click the [Set] button.
Description
Enter the port number to be used for Panasonic alarm protocol.
Specifies the number of retries when sending to the PC is
unsuccessful.
Specifies the address of the Panasonic alarm protocol
destination PC. Enter an IP address or host name for
addresses 1 through 4.
• Enter up to 255 single-byte alphanumeric characters,
including hyphen (-) and period (.).
• When entering a host name, you must use the DNS.
Network
67