Server; Ntp - Panasonic WJ-ND400K Setup Instructions

Server

NTP

Configures settings for clock adjustment based on an NTP (Network Time Protocol) server.
1
Click the [Server] button on the setup menu.
2
On the sub-menu that appears, click [NTP].
This will display the "NTP Setup" window.
NTP settings
Item
Time adjustment
NTP server address
♦Initial default
Important:
• "Time adjustment" may not operate when the recorder's DHCP setting is [On] and operating, and the time setting for NTP server and
recorder are more than 1000 seconds out of sync.
• About the NTP Server Function
The recorder can operate as a camera's NTP server. When it does, set the port number of the camera to 123.
For information about camera settings, refer to the camera operating instructions.
Settings
Off♦ / On
Address input
(Blank♦)
3
Configure the settings for each item.
Refer to "NTP settings" table for details about the settings.
4
Click the [Set] button.
Description
Specifies whether an NTP server is used.
Enter the name or IP address of the NTP server. When entering
a server name, you must use the DNS.
• Enter up to 255 single-byte alpha-numeric characters,
including hyphen (-) and period (.).
55