Command Alarm - Panasonic WJ-ND400K Setup Instructions

Command alarm

Use the following procedure to configure settings that control command alarm action when an event occurs.
1
Click the [Event] button on the setup menu.
2
On the sub-menu that appears, click [Command alarm].
This will display the command alarm setting window.
Command alarm settings
Item
Rec. cam.
Preset position
Output terminal
♦Initial default
Settings
Cam.1 to Cam.64 / --
Number input
(Blank♦)
Off / On♦
3
Configure the settings for each item.
Refer to "Command alarm settings" table for details about the
settings.
• To configure the settings of a command alarm that is not
shown on the display, click the applicable command alarm
number range above the [Set] button to change the
contents of the display.
• Clicking a command number saves the currently
displayed command settings.
4
Click the [Set] button.
Description
Specifies the channel of the recording camera.
Specifies the preset position (1 to 256) during alarm input.
• When this setting is blank, the camera does not move to a
preset position.
Specifies whether an alarm signal should be output when an
event occurs.
Event
41