Network Settings; Recorder Network Settings - Panasonic WJ-ND400K Setup Instructions

Network settings

Recorder network settings

This section explains how to configure recorder network settings.
The following are the settings for ports to be used.
Set the parameters using the button on the front panel. Setting parameters are displayed on the LCD.
Setting item
DHCP
IP address
Subnet mask
Default gateway
HTTP port
The following shows the factory default network settings.
Setting item
DHCP
IP address
Subnet mask
Default gateway
HTTP port
Important:
• Always configure the network settings for the ports using different subnet mask areas. Using the same subnet mask area may result in
improper network communication.
Note:
• Settings are not required when the PC network environment is as shown below. You can configure recorder settings and perform operations
from a web browser after connecting.
IP address : 192.168.1.2 to 249, 192.168.1.251 to 254
Subnet mask : 255.255.255.0
Gateway : 192.168.1.1
In an environment with other settings than those shown above, you will need to configure the network settings of the recorder or PC.
• For camera network settings, call up the Camera setup menu. Refer to "NW camera (page 48)" for details about the settings.
Specifies whether a DHCP server is used. Select [On] for this setting to obtain the IP address,
subnet mask, and default gateway from a DHCP server.
When DHCP is [Off], specify the IP address.
When DHCP is [Off], specify the IP address.
When DHCP is [Off], specify the default gateway subnet mask.
Specify the HTTP port number to be used. Normally this setting is 80.
Camera port
−
192.168.0.250
255.255.255.0
−
−
Description
Client PC port Maintenance port
Off
192.168.1.250
255.255.255.0
192.168.1.1
80
−
192.168.2.250
255.255.255.0
−
−
11