Network Disk Recorder
WJ-ND400K, WJ-ND400K/G
The Quick Reference Guide provides simple explanations of how to operate this recorder.
Network settings
■
Configure the network settings such as the IP address, subnet mask, etc. for each port.
LCD
[ESC] button
[SET] button
Arrow buttons
● IP address setup display
[SET]
■ Display the operation window
Display the operation window using a web browser installed on a PC.
Launch a web browser. After the web
browser starts, enter the IP address set
to this recorder in the address box, and
press the enter key.
Enter the registered user name and
password to log in to the recorder.
• Default
User name:
ADMIN
Password:
12345
Click the [login] button.
● Default network settings
Camera port
Item
DHCP
IP address
192.168.0.250
Subnet mask
255.255.255.0
Default gateway
HTTP port
● How to configure the network settings
Repeat pressing the arrow button (up
or down) until the "IP Address Setup"
indication is displayed. When the "IP
Address Setup" indication is displayed,
press the [SET] button.
• The current selected setup item or
a value will be indicated by the
underscore mark "_".
Press the [SET] button while the under-
score mark (_) is displayed below the ">"
indication.
Move the underscore mark below the
number to be edited.
To determine the edited setting, move
the underscore mark below the ">" indi-
cation by pressing the [ESC] button.
To display the time and date display
(standby display) again, press the [ESC]
button again.
→ The user authentication window will
be displayed.
→ The top page of the operation window
will be displayed.
• When the top page is displayed for
the first time, the install wizard of the
ActiveX control will be displayed.
Follow the instructions of the wizard.
Quick Reference Guide
Client PC port
[PT#1]
[PT#2]
_
OFF
192.168.1.250
255.255.255.0
_
192.168.1.1
_
80
→ The setup window will be displayed.
• When the underscore mark "_" is
below the ">" indication,
Arrow button (left or right): Select a
port number
Arrow button (up or down): Select a
setup item
→ The underscore mark "_" will move
below a setting value and the
editing of the settings became
enabled.
• Arrow button (left or right): Move the
underscore mark "_"
• Arrow button (up or down): Enter a
value
Maintenance port
[PT#3]
_
192.168.2.250
255.255.255.0
_
_