Configuration
8.
9.
10. Highlight the box beside Daytime, then press #. Use the Up and Down arrow
11. Highlight the Actions 1 and Actions 2 tabs to display the Motion Detection
Setting Motion Detection Actions
Document 800-04559 Rev D
11/09
Menu Item
Reverse All
OK
Cancel
You can control excessive event logging and remote notification of motions
detected after the motion dwell time by adjusting the motion ignoring dwell
intervals. Highlight the box beside Motion Ignoring Interval, then press #. A list of
intervals ranging from 1 to 5 seconds or Never appears. The DVR will not log and
notify motion events occurred during the preset interval range.
Note
The record action for motion events will not be affected by the
Motion Ignoring function.
Highlight Daytime Setup, then press # to set up the Daytime range.
buttons to set the Daytime range. The DVR will consider the remaining time range
as the Nighttime.
Figure 3-64
Actions 1 and Actions 2 screens.
The DVR can be set to react to motion detection differently for each camera. Each
camera can:
•
Be associated with another camera
•
Trigger an Alarm-Out connector
•
Sound the DVR's internal buzzer
•
Notify a number of different devices
•
Move PTZ cameras to preset positions
•
Display a camera on a SPOT monitor
Function
Activates inactive blocks and deactivates active blocks
Accepts changes and closes Zone setup
Exits Zone setup without saving changes
Daytime Setup Screen
89