Honeywell HRXDS16D1T User Manual page 41

Configuration
BACKWARD Button
the front panel is also used for Near Focus in the PTZ mode.
Enter Button
that you have made during system setup.
Up, Down, Left, Right Arrow Buttons
menus and GUI. You can also use them to change numbers by highlighting a number
in the menu and using the Up and Down arrow buttons to increase or decrease the
number's value.
The arrow buttons are also used to control Pan and Tilt when in the PTZ mode. When
in the PIP display format, pressing the Up and Down arrow buttons moves the position
of the small screen counter-clockwise and clockwise, and pressing the Left and Right
buttons moves through screen pages.
POWER LED
HDD LED
hard disk drive.
NETWORK LED
via Ethernet.
SPOT Button
Monitors. After selecting the monitor you can opt to have that Spot Monitor display a
single camera or all cameras sequentially. The infrared remote control allows you to go
directly to the individual Spot Monitor menus.
PTZ Button
control properly configured cameras.
FREEZE Button
clip-copying can be done instantly by pressing and holding the button for two or more
seconds.
ZOOM Button
rectangle temporarily displays showing what area of the screen has been enlarged. You
can use the arrow buttons to move the rectangle to another area. Press # to toggle the
zoom size between 2x, 3x and 4x.
ALARM Button
including the internal buzzer during an alarm. Second, it displays the event log when
you are in the live monitoring mode unless there is an active alarm. This operation can
be user password protected.
SEQUENCE Button
channels sequentially.
MENU Button
user and password to access Setup. Pressing MENU also closes the current menu or
setup dialog box. In the Playback mode, press MENU to display the Search menu. In
the Search mode clip-copying can be done instantly by pressing and holding the button
for two or more seconds.
Document 800-04559 Rev D
11/09
Press BACKWARD to go to the previous image. The button on
The (Enter) button selects a highlighted item or completes an entry
The POWER LED is lit when the unit is On.
The HDD LED flickers when the DVR is recording or searching video on the
The NETWORK LED flickers when the unit is connected to a network
Press SPOT to select which cameras will display on the four Spot
Press PTZ to enter the PTZ (Pan/Tilt/Zoom) mode which allows you to
Press FREEZE to freeze the current live screen. In the Search mode
Press ZOOM to zoom the current image on the screen. A PIP with a
The ALARM button has two functions. First, it resets the DVR's outputs,
When in the live mode, press SEQUENCE to display live
Press MENU to enter the Setup screen. You must enter the authorized
These buttons are used to navigate through
41