Video Clip Review
Video Clip Review
This appendix explains how to use the ClipPlayer program to review video clips.
You do not need to install any special software on your personal computer to review the
video clips. The copied video clip contains the ClipPlayer program.
If you used a USB device, disconnect either the external USB hard disk drive or USB
flash drive from the DVR, and connect it to your PC.
If you used a recordable CD, insert the CD in your computer's CD drive. Double-click
the target clip file to start the ClipPlayer program.
The ClipPlayer Screen (see
Document 800-04559 Rev D
11/09
Note
Honeywell suggests that the computer used for the ClipPlayer
program has at least an 800MHz Pentium III. If your CPU is
slower than this, video clips recorded at maximum speed with
very high image quality will be played back slowly. Also DirectX
9.0 or higher is required to run Clip Player, and a VGA card with
16MB or more video RAM is recommended for proper operation.
Figure
C-1) displays the clip images.
C
139