Honeywell HRXDS16D1T User Manual page 36

Caution
Caution
WARNING!
Your DVR is now ready to operate. Proceed to
Operation.
36
The power cord must be connected to the DVR before it is
connected to a wall outlet, otherwise, the DVR might NOT be
powered up properly. If the DVR is not turned on after connecting
the power cord, disconnect the power cord, wait 10 seconds, and
restart the DVR by following the proper connection procedures.
In noisy electrical environments, use an Uninterruptible Power
Supply (UPS) to minimize the potential of damage to the DVR
from undesired power related hazards. Connect the UPS between
the DVR and the AC voltage supply.
ROUTE POWER CORDS SO THAT THEY ARE NOT A
TRIPPING HAZARD. MAKE CERTAIN THE POWER CORD
WILL NOT BE PINCHED OR ABRADED BY FURNITURE.
DO NOT INSTALL POWER CORDS UNDER RUGS OR
CARPET.
THE POWER CORD HAS A GROUNDING PIN. IF YOUR
POWER OUTLET DOES NOT HAVE A GROUNDING PIN
RECEPTACLE, DO NOT MODIFY THE PLUG. DO NOT
OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY
DEVICES IN TO ONE CIRCUIT.
HRXDS Series DVR User Guide
Chapter 3, Configuration and Chapter 4,