Satisfaction Guide For 2-Sided Printing; Satisfaction Guide For Various Stocks - Xerox 6100BD - Phaser Color Laser Printer Manual

Satisfaction Guide for 2-Sided Printing

Stock Reliable feeds may be
expected
Size 8 x 10 inches to 17 x 11
inches (203 x 254 mm to
432 x 279 mm)
Weight Substance 16 to 110 (60 to
200 g/m2)
Substance 110 (200 g/m2)
must be long grain.
Type or Xerographic bond paper in
condition good condition
Drilled stock, fanned
thoroughly

Satisfaction Guide for Various Stocks

Stock type
•
Recycled Paper
•
Substance 13 (49 g/m2) paper
•
Substance 16 (60 g/m2) paper
•
Substance 20 (75 g/m2) paper
•
Card stock
•
Xerox substance 65 (176 g/m2)
•
Substance 110 (200 g/m2) long grain
(index)
•
Xerox 4024, substance 20 (75 g/m2)
•
3 hole drilled
•
4 hole drilled
•
7 hole drilled
•
Never-tear, 3 hole drilled
DT6180 HandyBook
Paper Trays & Loading Media
Less reliable feeds may be
expected
Slightly curled paper
Paper with reinforced edges
Instructions for use
Acceptable, but may increase paper dust
contamination problems in machine. Recommend
vacuum paper before installing in machine to
minimize paper dust.
Use trays 3,4,or 5.
Do not run 2-sided prints.
Load the paper with seam side down into tray 3.
Optimum satisfaction can be expected with 8.5 x
11 inch (216 x 279 mm) or larger paper.
Load paper with seam side up into trays 1 and 2;
seam side down into tray 3, 4, or 5.
Optimum satisfaction can be expected from tray
3, 4, or 5.
Load the paper with seam side up into trays 1
and 2; seam side down into trays 3, 4, and 5.
Card stock can be run from any tray.
Reduce set size if frequent paper jams or
bindexer jams occur. If collated unfinished,
another solution is to lower the value of the
bindexer capacity set in the SWITCHES mode.
Load the paper into trays 1 and 2 with holes to
the right; load the paper into trays 3, 4, and 5 with
holes to the left.
Use the Image Shift or Reduce/Enlarge options
to avoid printing near the holes.
Fan the paper and check the paper for loose
paper plugs before loading the paper into the
trays.
Load the paper into trays 1 and 2 with holes to
the right; load the paper into trays 3, 4, and 5 with
Suggested alternatives
17 x 11 inch (432 x 279 mm)
paper can only be sent to
the top tray.
Weights outside the limits
shown are not
recommended.
Do not use excessively
curled paper
Refer to the "Using various
stocks" section for any stock
not defined in this guide.
24