Replacing Consumables; Add Fuser Agent - Xerox 6100BD - Phaser Color Laser Printer Manual

4. Replacing Consumables

Add Fuser Agent

NOTE: You should add Fuser Agent as soon as possible after the message is displayed. If Fuser
Agent is not added the machine will stop running after approximately 5,000 prints and will not run
until Fuser Agent is added.
To add Fuser Agent:
1. Open the Processor Doors.
2. Place a drop cloth on the floor under the Fuser area to catch any Fuser Agent that may
spill.
WARNING: The Fuser area can reach temperatures of approximately 425 ° F / 218 °
C. Use extreme care to prevent burns when working in this area.
3. Grasp the green handle and lift up to open the Fuser Drawer.
4. Pull the Fuser Drawer all the way out of the machine until it stops.
WARNING: Fuser Agent contains silicone which can cause irritation upon contact
with the eye. Use latex gloves if you have them or make sure that you wash your
hands with soap and water after you finish this procedure.
5. Pull the Fuser Agent reservoir out until it stops.
6. Remove the reservoir cap.
DT6180 HandyBook
Replacing Consumables
29