Enable A Paper Tray For Clean Up; Enable Or Disable The Binder - Xerox 6100BD - Phaser Color Laser Printer Manual

book.
7. Close the Finisher Doors.
8. Run a test job to inspect your adjustment.
9. If necessary, perform the procedure again as needed.

Enable a Paper Tray for Clean up

If you are using DocuSP software version 3.x and above:
1. From the DocuSP for DocuTech 2000 Series for 61xx window, select [Printer Manager].
The Printer Manager window will be displayed.
2. Right-click on the tray and select [Enable Cleanup] from the menu. A broom, in the fourth
column from the left-hand side of the window, will mark the tray for clean up.
3. Repeat these steps until all trays you want enabled for clean up have a broom in column.
4. Select [Resume] in the Printer window.
If you are using DocuSP software version 2.x and below:
1. From the DocuSP Print Services window, select [Printer Manager]. The Printer Manager
window will be displayed.
2. Select the tray you wish to enable for clean up. A menu will be displayed.
3. Select [Enable Clean Up] from the menu.
4. Repeat these steps until all trays you want enabled have a green check mark in the
Clean Up column.
5. Select [Resume] in Printer window.

Enable or Disable the Binder

NOTE: You will need to logon as a System Administrator to perform this task.
To enable the Binder using DocuTech software version 3.x and above:
1. From the DocuSP for DocuTech 2000 Series for 61xx window, select [Printer Manager].
The Printer Manager window will be displayed.
2. Select the [Finishing] tab.
3. Under Internal Finishers, right-click on [Binder]. A menu will be displayed.
4. Select [Enable] or [Disable] from the menu. The status column will display the selection.
To enable the Binder using DocuTech software version 2.x and below:
1. From the DocuSP Print Services window, select [Printer Manager]. The Print Manager
window will be displayed.
2. In Printer Manager, select [Options]. A menu will be displayed.
3. Select [Finishing] from the menu. The Finishing window will be displayed.
4. Select the [On-line Finishers] tab.
5. Select [Binder].
6. Select the Binder check box to disable or enable the Binder. A check mark in the box
indicates the Binder is enabled.
7. Select [OK] to return to the Print Manager window.
DT6180 HandyBook
Machine Maintenance
47