Clean The Bin B Bindexer Sensor (Q1206) - Xerox 6100BD - Phaser Color Laser Printer Manual

5. Close and latch the bindexer door.
6. Close the left Finisher Door.

Clean the Bin B Bindexer Sensor (Q1206)

1. Open the left Finisher Door. The handle is above Paper Tray 3.
2. Open the Bindexer Door. The door is located above the Paper Tray 3 area. You should see a light
green triangle pointing to a latch which is surrounded by a light green rectangle. Pull the latch to the
left and open the door.
3. Inside you should see three shelves; each with an orange roller on it. Rest your index finger on any
one of the rollers. Lift your finger straight up until your fingernail is against the top of the shelf. Slide
your finger as far to the left of that shelf as you can. Your index finger should now be resting in a C-
shaped opening. There is a C-shaped opening for each shelf and that is where the Sensors are
located. The Q1206 Sensor is on the middle shelf.
4. Fold a piece of A4 (210 mm x 297 mm / 8.3 x 11.7 inch) or 8.5 x 11 inch paper. Brush the folded
piece of paper across each of the opening to make sure the sensor is clear of any obstructions.
5. Close and latch the Bindexer Door.
6. Close the left Finisher Door.
DT6180 HandyBook
Solutions in Alphabetical Order
72