Clear The Paper Jam In Areas 3 And 4 - Xerox 6100BD - Phaser Color Laser Printer Manual

Clear the Paper Jam in Areas 3 and 4

NOTE: Even if paper is not visible, go through the sequence to clear the paper jam. Carefully inspect the
rollers for any debris or torn pieces of paper. When clearing misfeeds, make sure a full sheet of paper is
cleared and there are no pieces of paper left in the machine.
To clear area 3:
1. Open the right Processor Door using the handle above Paper Tray 1.
2. Remove all paper in the area to the right of Paper Tray 2.
To clear area 4:
3. Grasp the green handle located in the lower left corner of the machine; approximately three inches
from the bottom.
4. Pull the handle out toward you, and up at the same time.
5. Remove all paper in the area below Paper Tray 2.
6. Pull the handle toward you, then release and lower the handle into position.
7. Close the Processor Door.
DT6180 HandyBook
Solutions in Alphabetical Order
111