Xerox 6100BD - Phaser Color Laser Printer Manual page 159

•
Tray 1 - 8.5x11, Red, Plain
•
Tray 2 - 8.5x11, Blue, Plain
•
Tray 3 - 8.5x11, White, Plain
2. Program the PCL Paper Source settings in the Queue Manager:
•
Standard &l1H = Red, Plain
•
Lower &l4H = Blue, Plain
•
Large Capacity &l5H = White, Plain
As you can see by this example, the PCL Paper Source programmed in Queue Properties does
not map the physical description of the trays of a corresponding tray on the DocuSP. It is merely
mapping an escape code to a media color and type that it will request. This is done because PCL
does not have a specific command for media color or type. The PCL interpreter, when it
encounters one of the escape sequences mention above, it will interpret the escape sequence as
a media color and type that is programmed in the PCL Paper Source and will request that media.
Which physical paper tray the media is loaded is of no concern, only that the size color and type
is loaded in any tray.
NOTE: The steps for versions 2.x and 3.x below are for the Detailed example, change your
entries accordingly.
DocuSP 3.x
Program the Paper Tray settings in the Printer Manager:
1. In the DocuSP for DocuTech 2000 Series 61xx window select [Printer Manager]. The
Printer Manager window will be displayed.
2. Right-click [Tray 1]. A menu will be displayed.
3. Select [Properties]. A Tray 1 - Properties window will be displayed.
4. Program the Size, Color, Type, and Weight for 8.5 x 11, Red, Plain, and 75 respectively.
5. Repeat steps 2-4 for trays 2 & 3, except program Color for Blue and White respectively.
Program the PCL Paper Source settings in the Queue Manager:
1. In the DocuSP for DocuTech 2000 Series 61xx window select [Queue Manager]. The
Queue Manager window will be displayed.
2. Right-click the Queue the job will be printed from. A menu will be displayed.
3. Select [Properties]. A Properties window will be displayed.
4. Select the [PCL] tab.
5. In the PCL section select the [Paper Sources] button. A PCL Paper Sources window will
be displayed.
6. Right-click on the [Standard] source. A menu will be displayed.
7. Select Properties. A Standard window will be displayed.
8. Program the Size, Color, Type, and Weight for US Letter, Red, Plain, and 75
respectively.
9. Select [OK].
10. Right-click on the [Lower] source. A menu will be displayed.
11. Select [Properties]. A Lower window will be displayed.
12. Program the Size, Color, Type, and Weight for US Letter, Blue, Plain, and 75
respectively.
13. Select [OK].
14. Right-click on the [Large Capacity] source. A menu will be displayed.
15. Select [Properties]. A Large Capacity window will be displayed.
16. Program the Size, Color, Type, and Weight for US Letter, White, Plain, and 75
respectively.
17. Select [OK].
DT6180 HandyBook
Programming Features
159