Clean The Tape Binder Area - Xerox 6100BD - Phaser Color Laser Printer Manual

Clean the Tape Binder Area

Clean the Binder Tape area:
NOTE: It is highly recommended that the Binder be cleaned before the Binder warm-up cycle begins or
before powering ON the machine.
1. Open the Finisher Doors.
WARNING: All areas of the Binder drawer, including the Binder tape, are hot (approximately
425º F, 218º C) and may cause a serious burn. If the Binder has been in a "Ready" condition,
allow the Binder to cool for at least one hour before continuing the procedure.
2. Grasp the green handle on the Binder drawer. Pull the drawer out until it stops.
CAUTION: To avoid damage to the system, do not use any liquids or any abrasive material
to clean the Binder. Use the plastic Binder Platen Cleaner on the tape reel or use a clean,
lint-free cloth.
WARNING: A sharp edge on the plastic Binder Platen Cleaner or on the Tape Spool
sometimes occurs as a result of removing the cleaner. This sharp edge could cut your
finger.
3. Locate and remove the plastic Binder Platen Cleaner from the Binder tape reel.
DT6180 HandyBook
Solutions in Alphabetical Order
89