Pioneer DVR-660H-S - 250GB HDD Multizoned DVR Operating Instructions Manual page 25

Connections
• When connecting a PC to this unit, make
sure the power is turned off on both the
PC and this unit when you connect them
via USB.
• We recommend connecting USB
devices when this recorder is switched
off (in standby).
• We recommend USB cables 2 meters in
length or shorter.
Connecting an HDD camcorder
On the recorder's HDD, video files can only
be copied with the signal format shown
below.
• Video recording format: MPEG-2 (PS)
• Image resolution: 720
352 480, 352 240
x x
• Audio recording format: Dolby Digital
• Use a USB cable (supplied with an
HDD camcorder) to connect the USB port
of your HDD camcorder to the front
panel USB port of this recorder.
HDD camcorder with which operation
is guaranteed (According to our
survey)
• SONY
DCR-SR300, DCR-SR62
JPEG file storage devices
• Digital still camera
• Memory card reader (any type of memory
card)
• USB memory
• PC (Use Connect PC function)
The Picture Transfer Protocol (PTP) can be
used to transfer up to a maximum of
4000 files.
Note
1 The MPEG-4 AAC files can be played or copied only with the DVR-660H-K.
480, 704 480,
x x
WMA/MP3/MPEG-4 AAC
storage devices
• Memory card reader (any type of memory
card)
• USB memory
• PC (Use Connect PC function)
Note that although multi-slot card readers
can be used, the recorder will only recognize
the first card inserted. To read another card,
remove all the cards and insert the card to be
read again.
Using a USB hub
• Use a hub compatible with USB 1.1 and/
or 2.0.
• Use an independently powered hub (bus
powered hubs may not work reliably).
• In the event of unreliable operation with
the hub, we recommend plugging the
device directly into the recorder's USB
port.
• Operation may become unreliable if too
many devices are connected to the hub.
In this case, try unplugging some
devices.
• If the power delivered through a hub is
insufficient for the devices connected,
communication can become unreliable.
In this case, disconnect one or more
devices then perform a USB restart. (See
Restart USB Device on page 122.)
Using a USB printer
• Use a PictBridge-compatible printer.
Using a USB keyboard
• Do not use a PS/2 keyboard connected
using a PS/2-USB adapter.
Using a PC
• Note that you can connect a PC to this
device via USB to copy WMA/MP3/
1
MPEG-4 AAC , JPEG and DivX files. For
more information, see Copying files from
a PC (Connect PC) on page 102. To use
02
1
file
25
En