Pioneer DVR-660H-S - 250GB HDD Multizoned DVR Operating Instructions Manual page 121

The Initial Setup menu
Setting Options
Network (DVR-660H-K only)
IP Config. Next Screen
• If you want to set the IP address manually, Set Auto Set IP Address to Off then set the IP address, Subnet mask
and Default gateway: Use the / buttons to select the address, press ENTER, use the / buttons to select a
field; use the number buttons to enter a value. Select Set, then press ENTER.
• The IP address determined by the Auto IP function is 169.254.X.X. The functions for searching for titles in the
Gracenote database on the network and the Connect PC function with an Ethernet connection cannot be used if
the IP address is set for the Auto IP function.
• When inputting the IP address, set within the range shown below. The functions for searching for titles in the
Gracenote database on the network and the Connect PC function with an Ethernet connection cannot be used if
other IP addresses are set.
–
CLASS A: 10.0.0.1 to 10.255.255.254
–
CLASS B: 172.16.0.1 to 172.31.255.254
–
CLASS C: 192.168.0.1 to 192.168.255.254
• For information on DHCP refer to the network device's operating instructions.
•You may need to contact your service provider or network administrator when manually entering an IP address.
• If you want to set the DNS address manually, Set Auto DNS Address Get to Off then set the DNS (Primary) and
DNS (Secondary).
• When Auto Set IP Address is set to Off, Auto DNS Address Get is also set to Off.
Proxy Server Next Screen
Config.
Display Network Next Screen
Config.
Test Start
If Connection failed. is displayed, check the IP Config. and Proxy Server Config. settings.
Options
On Screen On •
Display
Off
Explanation
Set Auto Set IP Address to On. If there is a DHCP (Dynamic
Host Configuration Protocol) server on the local area network
(LAN), this recorder will automatically be allocated an IP
address. If you're using a broadband router or broadband
modem that has a DHCP server function, select On. The IP
address will automatically be determined.
If there is no DHCP server on the network and you select On,
this recorder will use its own Auto IP function to determine
the IP address.
Set Auto DNS Address Get to On. If the DHCP function can
be used with a broadband router or a broadband modem
equipped with a router function, the DNS (Domain Name
System) server address can normally be set automatically.
Only set the proxy if so instructed by your provider. Set Proxy
Server to On then set the IP address or Server name and
Port number.
A list of network settings is displayed.
Connection to the network is tested. The result of the test is
displayed.
The recorder displays operation displays (Stop, Play, etc.)
on-screen.
Switches off the on-screen operation displays.
16
121
En