Pioneer DVR-530H Update Manual

Using the Update Disc for DVR-630H-S/DVR-530H-S/DVR-433H-S/DVR-433-K
The updating process does not erase the recorded titles, timer recording settings, various system settings of this
unit, and saved program guide data.
The Updating Procedure for DVR-630H-S/DVR-530H-S/DVR-433H-S/DVR-433H-K (steps 1 to 8)
• Use the update disc and carry out the following updating procedure.
• Use the control buttons on the main unit for all operations.
1 4
• Steps to give details about your operations while steps
Notes
• It takes approximately 5 minutes for the updating process to complete.
• The disc tray automatically opens during the updating process. If this unit is mounted in a rack with doors,
be sure to open the doors in advance.
• DO NOT switch off the power, unplug the power cord, or close the disc tray by force.
• Other operations and timer recordings are not available during the updating process.
Press STANDBY/ON to switch on this unit.
1
P O W E R O N
Press 0 OPEN/CLOSE to open the disc tray.
2
Load the update disc on the disc tray. Do not
3
close the disc tray.
Press (PLAY) while holding down
4
REC).
STANDBY/ON OPEN/CLOSE
DVR-630H-S/DVR-530H-S
STANDBY/ON OPEN/CLOSE
DVR-433H-S/DVR-433H-K
(STOP
& (STOP REC)
(PLAY)
& (STOP REC)
(PLAY)
5 8
to explain the status of this unit.
5
The disc tray automatically closes. Stop holding
down button and do not perform any operations
until the updating process completes in step 8.
6
The disc tray opens after a while. Remove the
update disc from the disc tray. Do not close the
disc tray but leave it open.
7
The updating process begins. "LOAD" appears in
the front panel display, and the display changes
as follows:
DOWNLOAD 1
DOWNLOAD 2
DOWNLOAD 3
DOWNLOAD 4
8
The disc tray automatically closes after
approximately 5 minutes, and the power is
switched off. This completes the updating
PULL - OPEN
procedure.
If "WRT FAILED" or "HDD ERR" appears in the front
panel display, switch off the power and follow the
updating procedure again from step
("HDD ERR" continues to be displayed, but you can
perform the updating procedure with the same
operations as described above.)
1
.
<UPD0020-A>