Pioneer DVR-660H-S - 250GB HDD Multizoned DVR Operating Instructions Manual page 114

The Initial Setup menu
16
Setting
VCR Plus+ CH
Setting
Video Out
Component
Video Out
• If your TV is incompatible with progressive scan video and you select Progressive, you will not be able to see any
picture at all. In this case, press  OPEN/CLOSE while holding down the  (Stop) button on the front panel to
switch to Interlace (this also switches Screen Resolution on page 119 to the default setting).
•
When the HDMI signal is output, no video is output from the COMPONENT VIDEO OUT
Audio In
External Audio
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder
whether the audio is stereo or dual mono. This has priority over the setting you make here.
Dual Mono
Recording
When recording dual mono audio to DVD in VR mode (except in LPCM mode), or to HDD with HDD Recording
Format set to Video Mode Off (except in LPCM mode), both audio channels are recorded and you can switch to the
one you want on playback.
114
En
Options Explanation
Next Screen Guide channels are used by the VCR Plus+ system so that
the channel number specified in the VCR Plus+
programming numbers can be guaranteed to correspond to
the correct station. Look in your TV guide to see which
channel numbers should be assigned to which guide
channels.
• Use the / buttons to change the guide channel for
setting.
• Use the / buttons to change the channel number.
• Use the PREV / NEXT
previous/next 10 guide channels.
• To return to the Initial Setup menu, press ENTER.
Select if your monitor/TV is not compatible with progressive-
Interlace •
scan video.
Progressive Select if your monitor/TV is progressive-scan compatible.
Check the operating instructions that came with your
monitor/TV if you're not sure.
Stereo • Select if the audio from the currently selected external input
is standard stereo.
Select if each channel carries a separate soundtrack.
Dual Mono
Select to record the left channel of an external dual mono
L •
source when recording to DVD in Video mode, to HDD with
HDD Recording Format set to Video Mode On, or in LPCM
mode.
As above, but for right channel recording.
R

button to display the
.