Connecting The Serial Cable - HP StorageWorks 2/32 - SAN Switch Installation Manual

Figure 14: Connecting the Serial cable
3. Connect the other end of the serial cable to an RS-232 serial port on the
4. Verify that the switch power is on and POST is completed. See the
5. Power on the workstation and establish a connection to the switch using a
Note:
different application, consult that application's documentation.
6. Using HyperTerminal (or similar application), configure the port settings as
SAN Switch 2/32 Version 4.2.x Installation Guide
workstation. If no RS-232 serial port is available on the workstation, the
adapter on the end of the serial cable can be removed to use the RJ-45
connector to create a serial connection.
Self-Test" section, earlier in this chapter.
terminal emulator application (such as HyperTerminal).
These steps show instructions specific to HyperTerminal. If you are using a
follows:
Bits per second: 9600
Databits: 8
Parity: None
Stop bits: 1
Installing the SAN Switch 2/32
SHR-2572A
"Power On
41