Connecting Ac Power; Connecting The Power Cords - HP StorageWorks SAN Switch 2/32 Installation Manual

Connecting AC Power

Use these steps to power on the SAN Switch 2/32.
CAUTION: Do not plug the power cords into the power source until the switch is
completely installed in the rack.
1. Connect the SAN Switch 2/32 power cords to the power connectors on the switch,
see Figure 2–10.
Figure 2–10: Connecting the power cords
2. Attach the remaining ends of the power cords to power outlets.
3. Turn on the power switch (the 1 position indicates power on, the O position
indicates power off). The switch automatically runs POST.
CAUTION: Do not connect the switch to the network until the IP address is correctly
set. For instructions on setting the IP address, see "Configuring SAN Switch 2/32
Network Addressing," later in this chapter.
SAN switch 2/32 version 4.0.x installation guide
Installing the SAN Switch 2/32
SHR-2571A
2–21 2–21