Inserting The Rear Cage Nuts In The Rack; Finalizing The Rack-Mounting Procedure; Installing The Director In The Rack; Securing The Front Mounting Brackets To The Rack - HP StorageWorks Director 2/140 Installation Manual

Inserting the Rear Cage Nuts in the Rack

Use these steps to insert the six (6) supplied cage nuts in the rack's rear rails.
1. Select one of the exterior vertical rails at the rear of the cabinet. From the
2. Count up 4U (12 holes) from the cage nut you just installed, and insert the
3. Count up 4U (12 holes) from the second cage nut and insert the third cage nut.
4. To install cage nuts in the other rear rail, repeat

Finalizing the Rack-Mounting Procedure

After completing the steps outlined in the previous section, prepare to orient the
Director 2/140 in the rack as described in the following sections. The procedure
requires two technicians.

Installing the Director in the Rack

Use these steps to maneuver the Director 2/140 into the rack:
1. Using a lift device, position the Director 2/140 at the front of the cabinet.
2. If necessary, adjust the lift height so that the bottom of the Director 2/140 is
3. Slide the director along the shelf mounts and into the cabinet until the front

Securing the Front Mounting Brackets to the Rack

Follow this procedure to secure the front mounting brackets attached to the
Director 2/140 to the rack:
1. Secure one of the front mounting brackets to a cabinet rail by attaching
2. Repeat
Director 2/140 Installation Guide
bottom of the shelf bracket, count up 3U (9 holes) and insert the first of three
cage nuts.
next cage nut.
Caution: The director weighs approximately 167 lbs. Do not attempt to lift or
carry the director with fewer than two people. Failure to observe this
CAUTION may result in injury to personnel or damage to the director.
parallel with the shelf mounts in the rack.
mounting brackets on the Director 2/140 contact the front cabinet rails.
three (3) Phillips panhead screws to the cage nuts you installed earlier.
step 1 to secure the other front mounting bracket to the remaining
cabinet rail.
Installing and Configuring the Director
step 1 through step 3.
49