Client Router - EnGenius ENH200 User Manual

12.4 Client Router

In Client Router Mode, the ENH200's internal DHCP server allows LANs to automatically
generate an IP address to share the same Internet. Connect an Access Point/WISP wirelessly
and connect to LANs using a wired connection.
Refer to Chapter 13 to check the Access Point's configuration.
Client Router
Step1
Step2
Step3
Step4
Step5
Step6
Step7
Step8
Step9
Client Router's IP setting must match to the Access Point's subnet.
Log in to the Web Configurator with the default IP address
192.168.1.1
Select your country or region's regulation.
For Operation Mode, select Client Router from System
Properties.
Change your Local Area Network setting to Obtain an IP
Address Automatically.
Use site survey to scan Access Points that are available in
nearby areas.
Select the Access Point with you want to associate.
Set up authentication settings that match the Access Point's
settings.
Set your WAN connection type using the WAN settings provided
by your ISP.
Click Apply to save all changes.