Chapter 7 System; Changing Operating Modes - EnGenius ENH200 User Manual

Chapter 7 System

This chapter describes how to change the ENH200 operating modes.

7.1 Changing Operating Modes

The ENH200 supports four operating modes:
Access Point
-
Client Bridge
-
- WDS Bridge
Client Router
-
To select an operating mode, click System Properties under System Section. Then
go to System > Operation mode.
.
Device Name: Enter a name for the device. The name you type appears in SNMP
management. This name is not the SSID and is not broadcast to other devices.
Country/Region: Select a Country/Region to conform to local regulations.
Operation Mode: Use the radio button to select an operating mode. To use Access Point
mode with WDS, select Access Point here and then enable the WDS function in the
Wireless Network section (see section 8.6).
Click Accept to confirm the changes.