EnGenius ENH200 User Manual page 64

Login
Password
Service Name
Connect on Demand
Keep Alive
Get Automatically
From ISP
Use These DNS
Servers
Discard Ping on WAN
Accept / Cancel
Clicking Accept does not apply the changes. To apply them, use Status > Save/Load (see
section 4.1).
setting that is too low can prevent the ENH200 from establishing
some connections.
Enter the Username provided by your ISP.
Enter the Password provided by your ISP.
Enter the Service Name provided by your ISP.
Select the radio button to specify the maximum idle time. Internet
connection will disconnect when it reach the maximum idle time,
but it will automatically connect when user tries to access the
network.
Select whether to keep the Internet connection always on, or
enter a redial period once the internet lose connection.
Select whether to obtain the DNS automatically from the DHCP
server.
Click the radio button to set up the Primary DNS and Secondary
DNS servers manually.
Check to Enable to recognize pings on the ENH200 WAN
interface or Disable to block pings on the ENH200 WAN
interface. Note: Pinging IP addresses is a common method used
by hackers to test whether the IP address is valid. Blocking pings
provides some extra security from hackers.
Click Accept to confirm the changes or Cancel to cancel and
return previous settings.