EnGenius ENH200 User Manual page 66

MTU
IP Address
IP Subnet Mask
Gateway IP Address
PPTP Server
Username
Password
Connect on Demand
Keep Alive
Get Automatically
From ISP
Use These DNS
Servers
Discard Ping on WAN
Accept / Cancel
Clicking Accept does not apply the changes. To apply them, use Status > Save/Load (see
section 4.1).
Specify the Maximum Transmit Unit size. It is recommended you
accept the default setting of Auto. Otherwise, packets will be
fragmented downstream if the MTU is set too high or too low,
which impacts network performance. In extreme cases, an MTU
setting that is too low can prevent the ENH200 from establishing
some connections.
Enter the WAN port IP address.
Enter the WAN IP subnet mask.
Enter the WAN gateway IP address.
Enter the IP address of the PPTP server.
Enter the username provided by your ISP.
Enter the password provided by your ISP.
If you want the ENH200 to end the Internet connection after it has
been inactive for a period of time, select this option and enter the
number of minutes you want that period of inactivity to last.
If you want the ENH200 to periodically check your Internet
connection, select this option. Then specify how often you want
the ENH200 to check the Internet connection. If the connection is
down, the ENH200 automatically re-establishes your connection
Obtains the DNS automatically from DHCP server.
Click the radio button to set up the Primary DNS and Secondary
DNS servers manually.
Check to Enable to recognize pings on the ENH200 WAN
interface or Disable to block pings on the ENH200 WAN
interface. Note: Pinging IP addresses is a common method used
by hackers to test whether the IP address is valid. Blocking pings
provides some extra security from hackers.
Click Accept to confirm the changes or Cancel to cancel and
return previous settings.