Network Connection - Oki MB491 User Manual

Network Connection

Do the following procedure to connect your
machine to a computer via network.
Connecting an Ethernet Cable
Be sure to connect your machine to a network
with an Ethernet cable before driver installation.
Prepare an Ethernet cable and a hub.
1
Prepare an Ethernet cable (category 5, twisted
pair, straight) and a hub separately.
Hold down the power switch for about a
2
second to turn on the power and a
computer.
Reference
"Turning Off Your Machine" P. 20
Plug one end of the Ethernet cable into
3
the network interface connection on the
back of the machine.
2
Plug the other end of the Ethernet cable
4
into the hub.
Install a Printer and Fax Driver
(for Windows)
To complete the network connection with a
Windows computer, first set IP addresses for the
machine, and then install a printer and fax driver
on the computer.
If there is no DHCP server or BOOTP server on
the network, you need to manually configure the
IP address on the computer or machine.
Your network administrator or internet service
provider specifies an unique IP address for the
computer and your machine, set the IP
addresses manually.
Note
You need to complete the network setting of the computer
before this procedure.
To complete this procedure, you must be logged in as an
administrator.
When setting an IP address manually, ask the network
administrator or your internet service provider which IP
address to use. If the IP address is set wrong, the network
may go down or Internet access may be disabled.
Memo
If configuring a small network consisting of only your
machine and a computer, set IP addresses as shown below
(according to RFC1918).
For the computer
IP address :
Subnet mask :
Default gateway :
DNS server :
For the machine
IP address Set :
IP address:
Subnet Mask :
Default Gateway :
Network Scale :
To set [Network Scale], press the <SETTING> key and
then select [Admin Setup] > [Network Menu] >
[Network Setup] > [Network Scale].
First, Set the IP address of the machine.
Hold down the power switch for about a
1
second to turn on the power.
Press the <SETTING> key on the
2
operator panel.
Press the
3
press .
OK
- 47 -
Connecting to a Computer
192.168.0.1~254
255.255.255.0
not used
not used
Manual
192.168.0.1~254 (select a dif-
ferent value from the com-
puter)
255.255.255.0
0.0.0.0
Small
to select [Easy Setup], and
1