Turning On And Off Your Machine - Oki MB491 User Manual

Reinstall the image drum in the
15
printer:lower it into place in the printer
locating the pegs (1) at each end into
their slots in the sides of the printer
cavity (2).
1
2
Turn the lever in the direction shown.
16
The arrow on the lever should align with the arrow on
the image drum.
When the toner cartridge is not fully fixed , a decline in
print quality may occur.
Close the top cover.
17
Close the scanner unit.
18
Reference
Please refer to "Loading Paper" P. 32
how to load paper into the machine.

Turning On and Off Your Machine

Power Supply Conditions
The power supply must meet the following
conditions:
Current:
Frequency:
1
2
for information on
110 - 127VAC
(Range 99 - 140 VAC)
220 - 240VAC
(Range 198 - 264VAC)
50/60 Hz ± 2%
Note
If the power supply is unstable, use a voltage regulator.
The maximum power consumption of this machine is
950W. Ensure that the power supply is sufficient to operate
this machine.
We do not guarantee the operation where an uninterruptible
power system (UPS) or inverter is used. Do not use an
uninterruptible power system (UPS) or inverter.
There is a risk of getting
an electric shock and/or
WARNING
Be sure to cut off the power supply when attaching
or removing the power supply plug or the earth
wire.
Be sure to connect an earth wire to the grounding
terminal of exclusive use.
Please do not connect with the ground of a water
pipe, a gas pipe, and a telephone wire, and a light-
ning rod by any means.
Make sure to connect with the ground terminal
before connecting the power cord to the power
supply plug.
Be sure to perform extraction and insertion of a
power cord with a power supply plug.
Insert the power supply plug to the inside of wall
socket certainly.
Do not touch the power cord, or machine, if your
hands are wet.
Install a power cord in the place which is not
stepped on, and do not place a thing on a power
cord.
Do not twist, bind, or knot the power cord.
Please do not use the damaged power cord.
Do not carry out foot wiring.
Do not connect this machine and other electric
products to the same wall socket. If it connects
simultaneously with an air-conditioning machine, a
copying machine, shredder, etc. especially, a
machine may incorrect-operate by the electric
noise. When you connect with the same wall
socket unavoidably, please use a commercial noise
filter or a commercial noise cut transformer.
Use the attached power cord and insert it directory
with the ground terminal. Do not use the power
cord for other product for the machine.
Do not use an extended code. When you use it
unavoidably, use the thing more than rated 15A.
Use of an extended code may not operate a
machine normally by AC voltage descent.
During printing, do not shut off a power supply or
do not pull out a power supply plug.
When you use it neither for consecutive holidays
nor a travel for a long time, pull out a power cord.
Do not user attached power cord to the other
products.
- 19 -
Installing Your Machine
causing fire.
1