Nortel Ethernet Routing Switch 8300 Series; Routine Maintenance; Nn46200-514 03.01 Standard - Nortel 8300 Series Maintenance Manual

To configure the syslog facility, use the following command:
config sys syslog
The config sys syslog command includes the following options:
For the syslog host ID, the range is from 1 to 10.
config sys syslog
followed by:
info
host <id> address
<ipaddr>
host <id> create
host <id> delete
host <id> facility
<facility>
host <id>
<enable|disable>
host <id> info
host <id> mapinfo
<level>
host <id>
mapwarning <level>
host <id> maperror
<level>
Copyright © 2004-2007, Nortel Networks
.
Uploading the log or creating a syslog host to capture the log 75
Displays the current syslog settings.
Configures a host location for the syslog host.
•
address is the IP address of the UNIX system
syslog host
Creates a syslog host.
Deletes a syslog host.
Specifies the UNIX facility used in messages to the
syslog host.
•
facility is the UNIX system syslog host
facility (LOCAL0 to LOCAL7)
Enables or disables the syslog host.
Displays system log information for the specified
host. This command results in the same output
as the show sys syslog host <id> info
command. The ID ranges from 1 to 10.
Slastpecifies the syslog severity level to use for
Ethernet Routing Switch Information messages.
• level is {emergency|alert| critical|e
rror|warning| notice|info|debug}
Specifies the syslog severity to use for Ethernet
Routing Switch Warning messages.
• level is {emergency|alert| critical|e
rror|warning| notice|info|debug}
Specifies the syslog severity to use for Ethernet
Routing Switch Error messages.
• level is {emergency|alert| critical|e
rror|warning| notice|info|debug}

Nortel Ethernet Routing Switch 8300 Series

Routine Maintenance

NN46200-514 03.01 Standard

4.0 27 August 2007