Removing A Filler Panel - Nortel 8300 Series Maintenance Manual

You can add or replace a module with the power on or off.
To remove a module, see the next section,
To install a module, see
Removing a filler panel
Nortel ships the Ethernet Routing Switch 8000 series chassis with a filler
panel covering each empty module slot.
On a 8006, 8010, 8306, or 8310 Chassis, the filler panel covers an empty
module slot.
Before you can clean, you must remove the appropriate filler panel.
To remove a filler panel:
Step
1
Copyright © 2004-2007, Nortel Networks
.
Removing modules and cleaning slots and the backplane 27
CAUTION
Electrostatic discharge can damage hardware. Follow the
procedures in this section to protect your equipment from damage.
"Installing a module" (page
WARNING
Fiber optic equipment can emit laser or infrared light that can
injure your eyes. Never look into an optical fiber or connector port.
Always assume that fiber optic cables are connected to a light
source.
Action
Using a Phillips screwdriver, loosen the 2 captive screws that fasten
the filler panel to the chassis. See
8010, 8306, and 8310 Chassis" (page
Nortel Ethernet Routing Switch 8300 Series
Routine Maintenance
NN46200-514 03.01 Standard
4.0 27 August 2007
"Removing a module" (page
30).
"Removing a filler panel: 8006,
28).
28).