Ricoh SP4100N - Aficio SP B/W Laser Printer Software Manual page 251

Message
add_sess_IPv6: community <community name>
already defined.
add_sess_IPX: bad trap<IPX address>community
<community name>
add_sess_IPX: community <communityname>
already defined.
Attach FileServer= <file servername>
Attach to print queue <print queue name>
Authentication mode mismatch< SSID >
centrod is disabled.
Cannot create service connection
Cannot find rprinter (<print server name>/<printer
number>)
Change IP address from DHCP Server.
child process exec error! (process name)
Problem and solutions
The same community name already exists. Use
another community name.
The IPX address (00:00:00:00:00:00) is
unavailable when the community access type is
TRAP. Specify the host IPX address for the TRAP
destination.
The same community name already exists. Use
another community name.
Connection to the file server as the nearest server
has been established.
(In the print server mode) Attached to the print
queue.
Authentication mode is different to the AP. The
required SSID is the SSID of the access point
connected to when in infrastructure mode.
Communication via parallel connections
unavailable because centrod is disabled in the
security mode.
Enable centrod in the security mode.
(In the remote printer mode) Connection to the file
server has not been established. The number of file
server users may have exceeded the maximum
capacity of the file server.
The printer with the number displayed on the print
server does not exist. Make sure that the printer
number is registered on the print server.
The IP address changes when DHCP lease is
renewed. To always assign the same IP address,
set a static IP address to the DHCP server.
The network service failed to start. Turn the printer
off and then on. If this does not work, contact your
service or sales representative.
Message List
6
249