Ricoh SP4100N - Aficio SP B/W Laser Printer Software Manual page 209

View settings
msh> ifconfig
IPv4 Configuration
msh> ifconfig "interface_name" "parameter" "address"
• If you did not enter an interface name, it is automatically set to the Ethernet interface.
• wlan can be specified only when the IEEE 802.11b interface unit is installed.
ether
wlan
The following explains how to configure an IPv4 address 192.168.15.16 on Ethernet interface.
msh> ifconfig ether 192.168.15.16
IPv6 Configuration
msh> ifconfig ether inet6 "interface_name" "prefixlen"
The following explains how to configure a IPv6 address to 2001:DB8::100 with prefix length 64 on
the Ethernet interface.
msh> ifconfig ether inet6 2001:DB8::100 64
Netmask configuration
msh> ifconfig "interface_name" netmask "address"
The following explains how to configure a subnet mask 255.255.255.0 on Ethernet interface.
msh> ifconfig ether netmask 255.255.255.0
Broadcast address configuration
msh> ifconfig "interface_name" broadcast "address"
Changing the Interface
msh> ifconfig "interface" up
• You can specify either the Ethernet interface or IEEE 802.11b interface when using the optional
IEEE 802.11b interface unit is installed.
• To get the above addresses, contact your administrator.
• Use the default configuration if you cannot obtain setting addresses.
• The IP address, subnet mask and broadcast address are the same as that for the ethernet interface
and IEEE 802.11b interface.
• TCP/IP configuration is the same for both Ethernet and IEEE 802.11b interface. If interfaces are
changed, the new interface inherits the configuration.
Interface name
Remote Maintenance by telnet
Interface configured
Ethernet Interface
IEEE 802.11b Interface
6
207