Setup > Connection Recovery - Cisco Small Business WRP400 User Manual

Installing and Configuring Your Mobile Network
Setup > Connection Recovery
Setup > Connection Recovery
NOTE
Cisco WRP400 User Guide
An Internet connection can be established via the Ethernet Internet port or a USB
modem connected to the USB port. While both Ethernet and USB interfaces may
be connected, only one of them can be used to establish a link at a time.
By default, the WRP400 uses the Ethernet Internet connection when available. If
the Ethernet Internet connection fails, the WRP400 automatically attempts to bring
up another connection on another interface. This feature is called failover.
Whenever the Ethernet Internet connection recovers, the WRP400 automatically
attempts to bring back and recover the Ethernet Internet connection. This feature
is called Recovery.
After you enter settings on this page, click Save Settings to apply your changes, or
click Cancel Changes to cancel your changes.
Figure 22 Setup > Connection Recovery
5
46